VSCOM USB-COM PRO Manual do Utilizador Página 23
- Página / 31
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
4 Hardware Configuration
[2#1] USB-2COM PRO v1: please press <ENTER> to activate the menu
Figure 17: Open Terminal Configuration
Now press the “Config” button to enter the configuration mode. In your terminal screen a line
similar to the above will appear. If you carefully watch the software, you may notice the line
is written again and again. If your terminal application translates a <CR> to a <CR><LF>
sequence, it adds a Line Feed character to each line. So you’ll see the text quickly scroll in your
Windows. This is intentional, the Configuration mode redraws the screen, so you have a chance
to change the parameters of your terminal application. The line lists the USB-COM PRO found
using this serial port.
This redraw happens until you press the <Enter> key. The firmware in USB-COM PRO now
recognizes interactive input, so a redraw is no longer required. If you need a redraw later, just
press the <Enter> key.
'
&
$
%
0 - Exit
----------------------------------
1 - Show all port configurations
2 - Change port configurations
3 - Default port configurations
4 - Save port configurations
----------------------------------
5 - Show configuration file
6 - Upload configuration file
>
Figure 18: Terminal Main Menu
The Main Menu appears. In this and the other menus just type the character given at the beginning
of the line, to get the function described there. Hit the Enter key to activate the command. The
optional result as well as the menu will be written on the screen. Just test this by hitting ’0’ and
Enter to exit from the configuration. The blue Config LED will go off.
In the Main Menu (figure 18) the upper section provides for status information and manual configu-
ration of the serial ports. The lower section provides a method to save the configuration, especially
for a later upload of these parameters.
4.2.1 Exit the Configuration (0)
> 0
Figure 19: Exit Terminal Configuration
Enter a ’0’ in the Main Menu, this will terminate the Configuration. The blue LED in the “Con-
fig” button will be off, unsaved changes to the configuration are discarded. The serial port is
disconnected from the Configuration hardware, and re-attached to the serial device.
June 2009 USB-COM PRO User Manual 23
- Tel: +49 40 528 401 0 1
- Fax: +49 40 528 401 99 1
- Web: www.visionsystems.de 1
- Copyright Notice 2
- Trademarks 2
- Disclaimer 2
- Contents 3
- List of Figures 4
- List of Tables 4
- 1 Overview 5
- 2 Introduction 5
- 2.2 Product Specifications 6
- 2.3 Packing List 9
- 2.4 About this Manual 9
- 3 The Drivers for Windows 10
- 3.3 Configure the Serial Ports 14
- 4 Hardware Configuration 19
- 5.1 Transmission Technique 27
- 5.2 Termination 27
- 5.3 Polarization 28
- 5.4 2-Wire Scheme 28
- 5.5 4-Wire Scheme 29
- 6 Connector Definitions 30
- 6.2 DB25 male RS 232 31
- 6.3 Terminal Block 31
Black & Decker HVLP400 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Narzędzia Black & Decker HVLP400.
Dostarczamy 1 pdf podręczników Black & Decker HVLP400 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentários a estes Manuais